Creating fractures in rocks with low permeability means that the water in the system can’t easily leak out

Tuesday, September 5th, 2023

Geothermal offers a virtually limitless, always-on source of emissions-free heat and electricity:

If the US could capture just 2% of the thermal energy available two to six miles beneath its surface, it could produce more than 2,000 times the nation’s total annual energy consumption.

But because of geological constraints, high capital costs and other challenges, we barely use it at all: today it accounts for 0.4% of US electricity generation.

To date, developers of geothermal power plants have largely been able to tap only the most promising and economical locations, like this stretch of Nevada. They’ve needed to be able to drill down to porous, permeable, hot rock at relatively low depths. The permeability of the rock is essential for enabling water to move between two human-drilled wells in such a system, but it’s also the feature that’s often missing in otherwise favorable areas.

Starting in the early 1970s, researchers at Los Alamos National Laboratory began to demonstrate that we could engineer our way around that limitation. They found that by using hydraulic fracturing techniques similar to those now employed in the oil and gas industry, they could create or widen cracks within relatively solid and very hot rock. Then they could add in water, essentially engineering radiators deep underground.

Such an “enhanced” geothermal system then basically works like any other, but it opens the possibility of building power plants in places where the rock isn’t already permeable enough to allow hot water to circulate easily. Researchers in the field have argued for decades that if we drive down the cost of such techniques, it will unlock vast new stretches of the planet for geothermal development.

A noted MIT study in 2006 estimated that with a $1 billion investment over 15 years, enhanced geothermal plants could produce 100 gigawatts of new capacity on the grid by 2050, putting it into the same league as more popular renewable sources. (By comparison, about 135 gigawatts of solar capacity and 140 gigawatts of wind have been installed across the US.)

[…]

Creating fractures in rocks with low permeability means that the water in the system can’t easily leak out into other areas. Consequently, if you close off the well system and keep pumping in water, you can build up mechanical pressure within the system, as the fractured rock sections push against the earth.

“The fractures are able to dilate and change shape, almost like balloons,” Norbeck says.

That pressure can then be put to use. In a series of modeling experiments, Fervo found that once the valve was opened again, those balloons effectively deflated, the flow of water increased, and electricity generation surged. If they “charged it” for days, by adding water but not letting it out, it could then generate electricity for days.

Comments

  1. Bruce says:

    https://news.stanford.edu/2019/05/23/lessons-south-korea-solving-geothermals-earthquake-problem/

    https://www.scientificamerican.com/article/geothermal-drilling-earthquakes/

    Scientific American:

    ‘Q: Do smaller earthquakes triggered by geothermal decrease the risk of large earthquakes?

    A: Unfortunately that’s a myth.’

    2009, so Scientific American may still have been trustworthy.

Leave a Reply